PT FORAGE HARVESTERS

THE BEST IN HIGH CAPACITY AND CHOP QUALITY

Gallery

TECHNICAL SPECIFICATIONS

Standard

Optional

Specifications


Weight (single axle), kg (lbs.)
Length, m (ft. in.)
Height with standard spout, m (ft. in.)
Width, m (ft. in.)
Number/type of knives
Cutterhead, type/speed
Cutterhead, diameter, mm (in.)
Throat opening, mm (in.)
Shearbar
Length of cut*, mm (in.)
Blower speed
Recommended max. tractor kW (hp)
Minimum power required kW (hp)
Knife sharpener
Recutter screens (non processor units)
Vertical wheel adjustment, mm (in.)
Tire sizes, single axle
Tire sizes, tandem axle
Metalert III

FP230	FP240
2040 (4,500)	2130 (4,700)
6.5 (21' 6")	6.5 (21' 6")
3.4 (11' 2")	3.4 (11' 2")
3.3 (10' 8")	3.3 (10' 8")
12 single-edge hardened alloy	12 single-edge hardened alloy
Cylinder, 850 rpm	Cylinder, 850 rpm
533 (21)	533 (21)
558 x 167 (22 x 6-5⁄8)	619 x 167 (24-3⁄8 x 6-5⁄8)
Quick adjust, reversible, hard-faced on vertical and horizontal surfaces	Quick adjust, reversible, hard-faced on vertical and horizontal surfaces
76 to 177 (3⁄16 to 7⁄16*)	76 to 177 (3⁄16 to 7⁄16*)
1,000	1,000
166 (225)	221 (300)
100 (135)	100 (135)
76 (3”) manual, built-in	76 (3”) manual, built-in
6 sizes available	6 sizes available
152 (6")	152 (6)
31x13.5-15 8PR standard/ 14Lx16.1 8PR optional	14Lx16.1 8PR standard
11Lx15-15 6PR	11Lx15-15 6PR

Optional CropPro™ crop processor


Optional CropPro™ crop processor
Construction
Weight, kg (lbs.)
Roll width, mm (in.)
Roll diameter, mm (in.)
Roll gap, mm to mm (in. to in.)
Roll speed rpm upper
Roll speed rpm lower

FP230	FP240
–
–	Hardened ductile iron, steel shaft
–	231 (520)
–	682 (26-7⁄8)
–	200 (7-7⁄8)
–	4 to 15 (3⁄16 to 5⁄8)
–	2,650
–	2,250

Standard Optional – Not available
* Longer lengths of cut can be obtained by removing knives—up to 15⁄16” length of cut with only four knives.
A range of corn & windrow pickup fronts are available.